Wake — On Lan Anydesk Hot

— works from any mobile hotspot, no networking knowledge needed.

🛠️ Requires precise configuration across BIOS/UEFI, Windows Device Manager, and AnyDesk settings.

Ensure your Network Interface Card (NIC) drivers are up to date. wake on lan anydesk hot

Think of it as a special wake-up call for your computer. When WoL is enabled on a device, its network card (NIC) remains in a low-power "listening" mode even when the PC is in sleep, hybrid shutdown, or even fully powered off (S5 state). This standby mode allows the NIC to listen for a specific network signal known as a

Your router must allow directed broadcast traffic (usually permitted by default). Step-by-Step Configuration: AnyDesk and WoL 1. Windows Network Adapter Configuration Open Device Manager . Expand Network adapters . — works from any mobile hotspot, no networking

Restart the target computer and enter the BIOS (usually by pressing , F2 , or F10 during startup). Navigate to the Power Management or Advanced tab.

: Uses any active AnyDesk device on the local network to wake the PC. Think of it as a special wake-up call for your computer

| Goal | Solution | |------|----------| | Reliable WoL over internet | Use a VPN (WireGuard/Tailscale) + keep a router/pi on-site to send WoL. | | Mobile hotspot + WoL | Almost impossible. Better to leave PC on low-power sleep (not shutdown) + use AnyDesk’s “keep connection alive”. | | AnyDesk auto-start after WoL | Set AnyDesk to launch at boot, disable password login for the user account, or enable auto-login. | | Hotkey simplicity | Use a tiny tool like wolcmd or PowerShell script bound to a hotkey (AutoHotkey or Shortcuts). |

:

Go to . Click "Change settings that are currently unavailable". Uncheck Turn on fast startup and save changes. 4. Activate WoL in AnyDesk Settings

To make this work, you need to configure your router to forward a specific UDP port to the sleeping computer.