Richmond Water Heater Model 6g40-36f1 Manual Today

Test the Temperature and Pressure Relief Valve annually to ensure it is operating properly.

Turn the gas control valve knob clockwise to the "OFF" position. Wait 5 minutes to let any residual gas clear out.

Continue holding the gas control knob down for approximately 30 to 60 seconds after the pilot lights. This allows the thermocouple/thermopile to heat up and generate the electrical current required to hold the internal safety valve open. richmond water heater model 6g40-36f1 manual

The manual specifies minimum clearances for this model:

The is a robust, reliable unit, but it is not forgiving of guesswork. Whether you are trying to light the pilot, replace the gas valve, or simply adjust the temperature, the manufacturer’s manual is non-negotiable for safety. Test the Temperature and Pressure Relief Valve annually

Release the knob. It should pop back up, and the pilot should stay lit. Turn the knob counter-clockwise to "ON".

Before performing any adjustments or maintenance, confirm your unit matches these baseline specifications outlined in the product documentation: 40 Gallons Gas Type: Natural Gas (Standard) Heat Input: 36,000 BTU/hr Continue holding the gas control knob down for

Atmospheric Vent (requires a draft hood and standard chimney or B-vent)

Attach a standard garden hose to the drain valve at the bottom of the tank. Route the other end to a safe drain or outside.

Click the piezo igniter button repeatedly until the pilot lights. Keep holding the gas knob down for 60 seconds. Release the knob; the pilot flame should stay lit. 3. Turning the Main Burner On Reinstall the outer burner access door. Turn the gas control knob counter-clockwise to . Set the temperature dial to your desired comfort level. 🔍 Troubleshooting Common Issues