: Unplug other printers or scanners to avoid sending the reset signal to the wrong machine.
Your printer has an internal "waste ink pad" (often called a "diaper" or "pampers" by technicians) that absorbs excess ink from cleaning cycles and printhead maintenance. The printer uses a software counter to track how much ink is collected. This counter is stored on an EPROM chip, which stands for Erasable Programmable Read-Only Memory. Think of it as the printer's internal memory chip.
🛠️ Step-by-Step Guide to Reset the Waste Ink Pad Counter
This method may not work on all 1410 variants. Test it if your printer has those physical buttons.
: Temporarily turn off all real-time protection and tamper protection, especially on Windows 10/11, as these programs often flag adjustment utilities as false positives. reset eprom epson 1410 adjustment program new
Turn your Epson 1410 back on. The alternate flashing red error lights will disappear, and the status monitor will display a "Ready to Print" message. Troubleshooting Common Adjustment Program Errors
Note: This article is accurate as of 2025. Epson may update firmware on newer printers to block these resets. If your 1410 has never been updated, do not connect it to the internet to avoid auto-updates.
In the dropdown, ensure Epson Stylus Photo 1410 is selected.
Resetting the EPROM/maintenance counter on an Epson 1410 using an adjustment program can restore printer functionality but must be done responsibly: verify and service waste-ink pads first, use suitable tools, and follow legal/environmental guidelines. When in doubt, seek authorized service. : Unplug other printers or scanners to avoid
To reset the EEPROM and waste ink pad counter on your , you must use a specialized Service Adjustment Program. This software communicates directly with the printer's internal memory (EEPROM) to clear "Service Required" errors caused by the ink pad counter reaching its limit. Preparation Requirements
Click the button. The tool will communicate with your printer and display your current page count percentage (it will likely show 100% or more). Step 5: Execute the Initialization Keep the Main Pad Counter box checked. Click the Initialization button.
Alternatively, open the bottom casing of the printer, pull out the saturated cotton pads, and replace them with fresh, absorbent material. 🔍 Troubleshooting Common Error Codes
Click when the prompt asks for permission to write the new data. Step 4: Finalize the EEPROM Reset This counter is stored on an EPROM chip,
If you encounter errors during the process, use these quick fixes:
To clear the waste pads: Check the boxes next to and FL Box Counter , then click Initialization .
The Adjustment Program runs exclusively on Windows operating systems (Windows 7, 8, 10, or 11).
After initializing your EEPROM counter, make sure to take one of these physical maintenance steps: