Onkyo Rc-799m Remote Manual Verified -

Press and hold the (or SETUP ) button simultaneously for 3 seconds.

Replace both AA batteries. Always replace them as a pair and do not mix old and new batteries. Cannot Control Other Components

Direct access to speaker calibration, HDMI settings, and audio adjustments.

Enter the 5-digit code using the number keys within 30 seconds. If the code is accepted, the button will flash twice.

Keep both buttons held down for approximately 3 seconds until the Remote Mode button lights up and stays lit. Release both buttons. onkyo rc-799m remote manual

Use the number buttons to input the for your TV brand. Example: A common code for Sharp TVs is 10818 .

Point the remote at your device and press ON/STANDBY . If the device turns off, the programming was successful. Test other keys like Volume or Menu navigation. 4. Popular 5-Digit Programming Codes

The Remote Mode button will flash twice, indicating the remote has successfully reverted to factory default settings. Using RI (Remote Interactive) Functions

If you cannot find your physical manual, there are several places to download digital versions for free: Press and hold the (or SETUP ) button

I can provide the exact codes and advanced configuration steps for your hardware setup. Share public link

Common codes for Onkyo receivers include , and 31298 . Key Button Functions

The indicator light will flash twice, confirming that all programmed device codes have been wiped and the remote has returned to its factory-default state. Where to Find Official Manuals and Support

The Ultimate Guide to the Onkyo RC-799M Remote Control: Manual, Setup, and Troubleshooting Cannot Control Other Components Direct access to speaker

Before diving into programming, here is a quick breakdown of the physical hardware: RC-799M (Part Number: 24140799) Signal Type: Infrared (IR) Battery Type: Two AA batteries (alkaline recommended)

Increases or decreases the master volume of the receiver.

Ensure you are holding down the TV and DISPLAY buttons simultaneously for at least 3-5 seconds until the LED illuminates. 6. Replacement Options

Do you need assistance identifying your ? Share public link

Use the number pad to enter the for your device.

Remove the batteries. Press every button on the remote twice to drain residual capacitance. Insert fresh batteries. 3. Lost Codes After Battery Changes