Laser Tool Setup V1.1.2.exe Download Work ((exclusive)) | Mks

A high-quality USB Type-B or USB Type-C data cable (avoid charge-only cables, which prevent the computer from assigning a COM port). 4. Step-by-Step Installation Guide

[ PC with MKS Tool ] ===(USB-C / Micro-USB Cable)===> [ MKS DLC32 Board ] ===> [ Laser Module ] Driver Requirements

: Ensure that you have the legal right to use the software and that you're using it in compliance with all relevant laws and regulations, including those related to laser safety. Mks Laser Tool Setup V1.1.2.exe Download WORK

Ultimate Guide to MKS Laser Tool Setup V1.1.2.exe Download and Configuration

Enables offline engraving without a permanently connected computer. Step-by-Step Download and Setup Guide 1. Download the Executable Navigate to the official Makerbase GitHub repository. Locate the MKS-DLC32 repository under the tools section. Download the clean Mks Laser Tool Setup V1.1.2.exe file. Avoid third-party forums to prevent malware risks. 2. Install CH340 USB Drivers Download the CH340 driver if your PC lacks it. Install the driver before plugging in the motherboard. This driver allows Windows to recognize the ESP32 chip. 3. Run the Installation Right-click the downloaded .exe file. Select to grant necessary permissions. Follow the on-screen prompts to complete the wizard. Launch the software from your desktop shortcut. How to Flash Firmware Using the Tool A high-quality USB Type-B or USB Type-C data

If you own a Makerbase MKS DLC32 motherboard or a compatible laser engraving machine, getting the right software communication link is critical. The is a dedicated utility designed by Makerbase to flash firmware, upload images, and configure Wi-Fi settings on your laser engraver.

Fix: This indicates an incorrect Baud Rate setting. Disconnect, switch the baud rate (usually toggling between 115200 and 250000), and reconnect. Ultimate Guide to MKS Laser Tool Setup V1

Right-click the file and select to ensure proper driver installation permissions.

Official versions and guides are typically hosted by hardware manufacturers who use MKS boards:

: Connect your engraver to your PC via a USB (Type-C) cable and power it on.

Connect your engraving machine to your local wireless network for remote control.