Lay down the new main body gasket. Lower the upper air horn onto the main body, ensuring the linkage rods align perfectly. Tighten the top screws in a criss-cross pattern to distribute pressure evenly. 🚗 Step 4: Installation on the Engine
Screw the primary and secondary jets firmly into their designated positions.
Accumulated gunk and varnish inside the carburetor is a primary cause of poor performance. maruti zen carburetor service manual
Reassemble the carburetor in the reverse order of disassembly, using all new gaskets and O-rings from the repair kit. Float Level Calibration
Use a tightly fitting flat-head screwdriver to remove the Main Jets and Pilot (Idle) Jet . Note: Do not mix up the primary and secondary main jets; they have different orifice sizes. Lay down the new main body gasket
Turn it clockwise to increase RPM or counter-clockwise to decrease RPM until the tachometer reads roughly . Step 3: Optimizing the Idle Mixture
To help you get the most accurate instructions, could you tell me: What is the of your Maruti Zen? 🚗 Step 4: Installation on the Engine Screw
Slowly turn the clockwise (leaning out the mixture). The engine RPM will begin to drop, and the engine may start to stumble.
Slowly turn the mixture screw clockwise until the engine begins to stumble.