Use a USB cable to connect the MKS DLC V2.1 to your computer. 5. Troubleshooting Common Issues
One of the most overlooked sections is the . If your board is not powering on or a heater fails:
Use the dedicated 3-pin or 2-pin laser control ports to manage laser power dynamically via software. makerbase mks dlc v21 manual link
Simply downloading the PDF is not enough. Here is how to extract real value from it.
$100 , $101 , $102 – Steps per millimeter for X, Y, and Z axes. Use a USB cable to connect the MKS DLC V2
Most Voron builders pair the MKS DLC V2.1 with Klipper. In your printer.cfg , reference the manual to find the correct [mcu] pins. Example snippet:
Understanding the hardware limits of the MKS DLC V2.1 ensures you do not damage the board during wiring. Specification ATmega328P (8-bit microcontroller) Input Voltage DC 12V to 24V Supported Stepper Drivers A4988, DRV8825, TMC2208, TMC2209, etc. (Step/Dir mode) Axes Supported 3-Axis (X, Y1, Y2, Z) - Dual Y-axis capability PC Interface USB (CH340 serial chip) Software Compatibility If your board is not powering on or
Are you planning to use this board for a or a CNC router project? MKS DLC V2.1_001 PIN.pdf - hardware - GitHub
https://github.com/makerbase-mks/MKS-DLC-V2.1
The board supports X-axis, Y-axis, and Y-axis slave (dual motors) in parallel. Connect to the X MOTOR connector. Y Axis: Connect to Y1 and Y2 if using dual motors.