Ki 256 Installation Manual ((link))

For more information on the KI 256 and its installation, please refer to the following resources:

(This is the most critical section for the KI 256 due to the VSI function)

The KI‑256 is available in two primary mounting configurations: ki 256 installation manual

Do you have the specific or model to find the exact STC-approved wiring diagram?

When updating internal parts, such as the Command Bar Board , technicians must verify that wire connection points match the original layout, though specific pin locations (like E114) may shift between board revisions. Verification and Compliance For more information on the KI 256 and

Review any relevant service bulletins (e.g., Ki 256 SB11) for modifications, such as replacing the command bar board, to ensure optimal performance. 2. Mechanical Installation The KI 256 fits a standard 3-inch instrument cut-out.

Additionally, the alignment procedure for the specific flight control system must be followed precisely. As noted in an official service bulletin, failure to align the system with a properly modded KI 256 can result in failure. As noted in an official service bulletin, failure

: Technical specifications and internal maintenance procedures are covered in Volume 3 Instrument Overhaul Manual (KPN 006-5146-00) Key Installation Specifications Power Requirements : Operates on +14VDC or +28VDC at 0.7 amps max, along with 10VAC, 430Hz. Panel Tilt Options

: Provides critical pitch and roll reference signals directly to flight computers like the KC-295 .

A 10VAC, 430Hz reference signal sent out by the autopilot computer to power the internal pick-off transformers.