Operating and programming a Gilbarco SK700 dispenser requires a clear understanding of these procedures. This guide provides a comprehensive starting point, but the official resources listed above are the definitive sources for all technical activities. Always prioritize safety and legal accuracy when configuring a fuel dispenser.
Calibrates the software safeguards to halt delivery if the physical blend deviates from the programmed parameters. Calibration and Meter Settings
The CPU memory corrupted. Perform a master cold start and reprogram. 💾 Performing a Master Reset (Cold Start)
Gilbarco SK700 fuel dispensers utilize a hierarchical command structure for programming, typically accessed via a manager keypad. Gilbarco Sk700 Programming Manual
For more complex feature integration, such as multimedia or payment systems: USB Configuration
Before starting any programming sequence, you set the dispenser to calibration mode. This is done by opening the appropriate calibration switch on the E-Cal Board or SIP. A key must be used to break the security seal and access the switch.
: This tells the pump you have permission to make changes. Calibrates the software safeguards to halt delivery if
Press the key to initiate the login prompt on the primary side display.
You must locate the physical manager switch on the main CPU board (often designated as the "Master Switch" or "Read/Write" jumper) to authorize configuration changes. Step-by-Step Entry Protocol
: Familiarize yourself with the communication protocols supported by the SK700, such as RS232, Ethernet, etc. 💾 Performing a Master Reset (Cold Start) Gilbarco
Programming is organized by function codes. Common configurations include: Pump Numbers: Command Code 40 in Level 2. Real-Time Volume/Money:
Setting the correct fuel pricing per grade is the most common manual programming task. : Typically accessed under Function 01.
According to the , entering the programming mode does not require a keypad—because the SK700 typically lacks one. Instead, programming is performed via a series of dip switches and push-buttons located inside the dispenser’s electronics enclosure.
Are you using or a specific POS interface protocol (e.g., IFSF, Two-Wire)?
: Find the toggle switch or button on the main CPU board (often labeled S1 or Manager Switch ).