Thread the provided Feed Water Adapter Valve onto the cold water shut-off valve. Ensure the rubber O-ring is seated properly.
Apply 4 to 5 wraps of Teflon tape clockwise onto all male threaded fittings. Install the inlet and outlet adapter valves onto your existing plumbing lines. Ensure the arrows on the valves match the direction of the water flow (Inlet = supply side, Outlet = faucet side). Step 4: Hang the Main Unit
A 30mA RCD must be installed in the circuit. galaxy aqua premier installation manual
To keep your Galaxy Aqua Premier running efficiently, perform regular maintenance.
Minimum running pressure of 1.0 bar (14.5 psi) is required. Thread the provided Feed Water Adapter Valve onto
: Replace the Stage 1 Sediment Filter and Stage 2 Carbon Block Filter to prevent clogging.
: He held the backplate against the wall, away from the direct spray of the handset. With a pencil, he marked the drilling points, careful to avoid the hidden pipes and cables lurking behind the tiles. Install the inlet and outlet adapter valves onto
Install the unit in a dry, ventilated area, away from direct sunlight, pests (ants/insects), and heating devices.
Route the tube to a drain point (e.g., floor drain, standpipe).
Complete Installation Guide for the Galaxy Aqua Premier Water Filtration System