Move the cursor to the target parameter number, type the new value, and press .
Over time, ballscrews wear out, resulting in "lost motion" when the machine changes direction. The Fanuc 10m allows you to input a physical compensation value.
For a basic connection, you’ll typically use a 3-wire cable (pins 2, 3, 7). However, for more reliable communication, a full 9-pin to 25-pin cable with hardware handshaking (RTS/CTS) is recommended. Fanuc 10m Parameter Manual
Some common parameters found in the Fanuc 10M parameter manual include:
Change the value from 0 to . The control will likely generate an alarm (e.g., "Parameter Write Enabled"). This is normal . Locate the Parameter: Press the [PARAM] key. Use the PAGE UP/DOWN keys to find the parameter number. Change the Value: Use the cursor to select the parameter. Type the new value and press the [INPUT] key. Turn Off PWE: Return to the [SETTING] screen. Change the PWE value back to 0 . Press the [RESET] button to clear the alarm. Protecting Your Investment: Backing Up Parameters Move the cursor to the target parameter number,
Critical for DNC (Distributed Numerical Control) and RS-232 serial port settings.
If you want to dive deeper into your machine's configuration, tell me: For a basic connection, you’ll typically use a
The Fanuc 10M control system relies on a vast array of parameters to define everything from hardware communication to specific axis movements. Effective management of these parameters is essential for maintaining machine accuracy and recovering from system failures. 1. Parameter Access and Modification
Locate Parameter #8000 (PWE). Move the cursor over to bit #0 (the far right) and change it to 1 by typing 1 and pressing INPUT .
