show interface brief (Shows all ports and their operational status).
Always save your work. Modifying parameters on a MINI-LINK node occurs in volatile memory until explicitly committed. copy running-config startup-config Use code with caution.
Used to set IP addresses, subnet masks, and default gateways for device management (DCN). Contextual Help: at any prompt to see available commands or press the key twice to display possible arguments. Scripting: MINI-LINK CLI Tool ericsson mini link cli commands
The following are some configuration CLI commands used in Ericsson Mini Link:
Troubleshooting degraded link
| Command | Function | | :--- | :--- | | | Displays the software and firmware versions, hardware revision, and uptime. Essential for inventory and compliance checks. | | show running-config | Shows the current, active configuration. This is the live configuration the node is using. | | show startup-config | Shows the saved configuration that will be loaded on the next reboot. | | show interfaces | Displays the status, statistics, and errors for all physical and virtual interfaces. A crucial command for link diagnostics. | | show clock | Verifies the system's time and date, which is critical for synchronization and accurate log correlation. | | show license | Shows all installed licenses and their status, which can be checked via the command get_license . | | show alarm | Lists all active alarms, their severity, and time of occurrence. A primary tool for fault management. | | show arp | Displays the ARP table, mapping IP addresses to MAC addresses on the local network. | | show ntp status | Shows the synchronization status with configured Network Time Protocol (NTP) servers. |
MINI-LINK platforms heavily utilize IP routing and VLAN switching for traffic aggregation. show interface brief (Shows all ports and their
set radio tx-power [value] : Adjusts the transmitter output power (configured in dBm).