This public link is valid for 7 days and shares a thread, including any personal information you added. This link or copies made by others cannot be deleted. If you share with third parties, their policies apply. Can’t copy the link right now. Try again later.
When flashing via USB, you may have used the wrong contact points (NAND shorting) to force the device into bootloader mode.
If you are reading this, you have likely been staring at a terminal screen, watching a flashing or bricked set-top box (STB), router, or development board refuse to boot. Instead of a normal startup sequence, your console is frozen on a cryptic red or yellow line of text:
This is a literal translation from low-level firmware code (often written by Chinese engineers for HiSilicon or Allwinner chips). It means: "The BootROM is currently waiting to receive a boot file or command." Bootrom Error Wait For Get Please Check Stb Uart Receive
Short TX and RX on the UART adapter. Open a terminal. Type characters – they should echo. If not, the adapter is faulty.
. Using a 5V adapter can cause communication errors or permanent damage. Confirm Serial Settings Common defaults are baud rate, 8 data bits 1 stop bit Enter Boot Mode Correctly
Try different software altogether, such as the Android Tool for Rockchip devices. Summary Checklist Use USB 2.0 (rear ports on PCs) Cable Use a short, high-quality USB-A to USB-A cable Driver Reinstall USB Burning Tool Drivers Method Re-short NAND pins carefully Power Switch on after USB connection This public link is valid for 7 days
: Disconnect your adapter from the STB mainboard. Take a jumper wire and bridge the TX and RX pins on your USB-to-TTL adapter together. Open a serial terminal program (like Putty, Tera Term, or Minicom), open your COM port, and type into the console. If the characters you type echo back onto the screen, your computer, adapter, and driver are working. If nothing echoes, your adapter or driver is broken.
If your PC sends 0xAA 0x55 but the SoC expects 0x55 0xAA (byte-swapped), the error triggers. Adjust in HiTool → Settings → "Swap bytes in UART".
The error indicates that the device's (the permanent instructions that start the hardware) is waiting for a "handshake" or data packet from the computer but is not receiving any. This usually happens during a "dead STB revival" or firmware update process. Common Causes Can’t copy the link right now
: Only now plug the power cable back into your STB or release its physical hardware Reset button.
If you are trying to update the firmware, flash a custom ROM, or restore an Android TV box (Set-Top Box - STB), and you encounter the error message: it means your computer is failing to communicate properly with the device during its initial boot phase [1].
Here is a systematic approach to diagnosing and fixing the error, from the simplest to the most advanced solutions.