Aei Dk 9830 Change Password Online

: If you’ve forgotten your Master Code, you may need to use the DAP (Direct Access to Programming) jumper inside the unit to reset it without losing user data.

Type the desired 4-digit PIN for the user (e.g., 5 6 7 8 ). Save the Code: Press the * key. Exit: Press the # key. Programming User Codes for Relay 2 (Secondary Output)

: Key in the current Master Code twice (the factory default is Enter the Programming Slot to select the Master Code recording slot. Enter Your New Code : Key in your new 4 to 8-digit Master Code. : Press the key to save the new code. Exit Programming : Press the key to exit the setup mode. 德信鎖類工程 Changing a User Code If the system is in Multi-User Mode , use the following sequence in Programming Mode: Select Slot (for Relay 1). User Number : Enter a 2-digit User ID (e.g., : Enter the new 4 to 8-digit User Code. : Press the 德信鎖類工程 Resetting a Forgotten Master Code (DAP Jumper)

Press the * key directly without entering any numbers. Exit: Press the # key. aei dk 9830 change password

Need to change the password on your AEI DK 9830 time clock or access control device? This detailed guide covers factory resets, software configuration, and troubleshooting common errors.

AEI DK-9830 Installation and Operation Instructions - Manualzz

Dimension: 117(H) mm x 117(W) mm x 21(D) mm. Weight: 150g (DK-9832). 145g (DK-9831). DK-9830 -- 1 OUTPUT: SINGLE RELAY OUTPUT. DK- www.aei.com.hk : If you’ve forgotten your Master Code, you

: Type your new 4 to 8 digit code, then press # . Confirm New Code : Repeat the new code and press # again. Exit : Press * to return to normal operation. 2. How to Change or Add User Codes

If an employee or tenant leaves, you should clear their specific slot immediately so their password no longer works. Enter Programming Mode: [Master Code] + [*]

: If you make a mistake, don't rush. Wait about 10 seconds for the keypad to reset before trying the sequence again. Exit: Press the # key

Type your Master Code twice (e.g., 4321 4321 ).

: Press 0000 (or your current master code) followed by the * or ** key (depending on the specific sub-model firmware). Enter the Change Command : Press 0 followed by the # key. Input New Code : Enter your new 4 to 8-digit master code. Confirm : Press the # key again to save. Exit : Press the * key to leave programming mode. Changing/Adding User Passwords User codes are stored in slots (User Numbers). Enter Programming Mode : Use your Master Code + * .

Do not use sequential sequences (e.g., 1234 ) or repeated digits ( 1111 ) for Master or User codes.

If the master code was never changed, you can log in with 123456 .